49
Appendix B: Beep alarm
The beep alarm can be disabled in “Control Panel” > “System Settings” > “Hardware”> “Buzzer”.
(0.5 Sec)
1) The ES NAS/SAN is starting up
2) The ES NAS/SAN is being shut down (software shutdown)
3) The user presses the reset button to reset the ES
NAS/SAN
4) The ES NAS is performing giveback.
(0.5 Sec)
The ES NAS is performing takeover.
(0.5 Sec)
The system firmware has been updated
(0.5 sec)
1) The system fan is out of function
2) Heart beat lost connection
(1.5 Sec)
1) The disk volume is going to be full
2) The disk volume has reached its full capacity
3) The hard drives on the ES NAS/SAN are in degraded mode
4) BBU/power supply plug-out
5) JBOD lost
1) The ES NAS/SAN is turned off by force shutdown
(hardware shutdown)
2) The ES NAS/SAN has been turned on successfully and is
ready
To Next Page
Loading...
Need help?
General
