Installing 2.5-inch Hard Drives or Solid State Drives
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove the drive tray.
a. Pull the handle to release the tray.
b. Pull the tray out.
3. Install a drive on the tray.
a. Place the tray on the drive so that the holes on the tray are aligned with those on the drive.
b. Attach the screws to lock the drive to the tray.
TS-x31P2 User Guide
Installation and Configuration 13
To Next Page
Loading...
Need help?
General
