LED Status Description
Gigabit LAN
(Rear)
Left Green The Ethernet port is connected to a 1 gigabit network.
Left Amber The Ethernet port is connect to a 100 megabit network.
Left Off The NAS is not connected to a network.
Right Green The Ethernet port is connected to a network.
Right flashes Green The NAS is being accessed on this Ethernet port.
Right Off The Ethernet port is not connected to a network.
Drive Green The drive is ready.
Flashes Green The drive is being accessed.
Red The drive has encountered an error.
Flashes Red 5 times per
second
The drive is being located in the operating system.
Off No drive is detected.
USB - One
Touch Copy
Blue A USB external storage device has been mounted
successfully on the USB One-Touch Copy port.
Flashes Blue 2 times per
second
• A USB external storage device connected to the USB
One Touch Copy port is being mounted.
• A USB external storage device connected to the USB
One Touch Copy port is being disconnected.
• A USB external storage device connected to the USB
One Touch Copy port is being accessed.
Off No USB external storage device is connected.
USB Blue A USB external storage device is connected to a USB port.
Off No USB external storage device is connected.
Beep Alarm
Duration Frequency Description
Short beep (0.5 seconds) 1 • The NAS is starting up.
• The NAS is shutting down (software shutdown).
• The user pressed the Reset button.
• The operating system was updated.
3 The user tried to copy the NAS data to the external
storage device from the front USB port, but the data
cannot be copied.
TS-x31P2 User Guide
Basic Operations 30
To Next Page
Loading...
Need help?
General
