EasyManua.ls Logo

QNAP TS 31P2 Series - User Manual

QNAP TS 31P2 Series
45 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TS-x31P2
TS-231P2
TS-431P2
User Guide
Document Version: 1
28/08/2017

Table of Contents

Questions and Answers

  • W
    William EllisonAug 10, 2025
    How to hot-swap failed drives in QNAP TS 31P2 Storage?
    • M
      Mary LoweryAug 10, 2025
      To replace a failed drive in your QNAP storage, log in to QTS and navigate to 'Main Menu > Storage Manager > Storage > Disks/VJBOD'. Find the failed drive, get a new hard drive with equal or greater capacity, physically remove the failed drive from the NAS, wait about 20 seconds (or until you hear two beeps), take the failed drive out of its tray, put the new drive in the tray, install it, and then check that the status shows 'Rebuilding'.
  • L
    Lucas SuttonAug 25, 2025
    What to do if Qfinder Pro or myQNAPCloud is unable to locate the QNAP TS 31P2 during QTS installation?
    • C
      Cody ChungAug 26, 2025
      If Qfinder Pro or myQNAPCloud can't find your QNAP NAS during QTS installation, the drives or data may be faulty. First, turn off the NAS. Then, remove all the drives and power the NAS back on. Use Qfinder Pro or myQNAPCloud to locate the NAS. Once found, reinsert the drives to continue the QTS installation.

QNAP TS 31P2 Series Specifications

General IconGeneral
BrandQNAP
ModelTS 31P2 Series
CategoryStorage
LanguageEnglish

Related product manuals