Replacing Memory Modules
The NAS has one memory slot. You can increase the memory capacity of the NAS by upgrading the memory
module. You can purchase QNAP memory modules from authorized resellers.
Warning
• Only qualified personnel should perform the following steps. Failure to follow
instructions can result in serious injury or death.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Disconnect the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the case cover.
a. Remove the screws that secure the cover to the chassis.
b. Slide the cover back.
c. Pull the cover up until it completely detaches from the chassis.
5. Remove an existing module.
a. Push the retention clips outward simultaneously to release the module.
TS-832X User Guide
Installation and Configuration 19
To Next Page
Loading...
Need help?
General
