QNAP TS-h1090FU - User Manual

Other manuals for QNAP TS-h1090FU

Questions and Answers

Kurt KnightAug 10, 2025

How to hot-swap failed drives on a QNAP TS-h1090FU Server?

S
Stephen PaceAug 10, 2025
To hot-swap failed drives on your QNAP Server, follow these steps: 1. Log on to QuTS hero. 2. Go to Main Menu > Storage & Snapshots > Storage > Disks/VJBOD. 3. Locate the failed drive. 4. Prepare a new hard drive with the same or larger capacity. 5. Remove the failed drive from the device and wait for 20 seconds or until the device beeps twice. 6. Remove the failed drive from the drive tray, insert the new drive into the drive tray, and install the new drive.

Paul MccoyAug 25, 2025

What to do if Qfinder Pro or myQNAPcloud is unable to locate the QNAP TS-h1090FU during QuTS hero installation?

D
Darryl PowellAug 26, 2025
If Qfinder Pro or myQNAPcloud can't find the QNAP Server during QuTS hero installation, it might be due to faulty drives or data. To resolve this, power off the NAS, remove all drives, power it back on, and use Qfinder Pro or myQNAPcloud to locate the NAS. Once found, reinsert the drives and continue with the QuTS hero installation.

QNAP TS-h1090FU Specifications

General

Model	TS-h1090FU
Category	Server
Maximum Memory	128 GB (4 x 32 GB)
Hot-swappable	Yes
2.5 Gigabit Ethernet Port (RJ45)	2
Form Factor	Tower
CPU Architecture	64-bit
Memory Slot	4 x UDIMM slots
Drive Bays	10
Drive Compatibility	2.5-inch SATA HDD/SSD, 3.5-inch SATA HDD
M.2 SSD Slot	2
10 Gigabit Ethernet Port	2
Slot 1	PCIe Gen3 x8
Slot 2	PCIe Gen3 x4
Slot 3	PCIe Gen3 x4
HDMI Output	1
Weight (Net)	10.5 kg
Operating Temperature	0 to 40 °C
Relative Humidity	5% to 95% (non-condensing)
Power Supply Unit	100-240V AC, 50/60Hz
Operating System	QuTS hero
PCIe Slots	3 Slot 1: PCIe Gen4 x16 Slot 2: PCIe Gen4 x4 Slot 3: PCIe Gen3 x4
USB Ports	2 x USB 3.2 Gen 2 10Gbps Type-A ports 2 x USB 3.2 Gen 1 5Gbps Type-A ports