QOLSYS IQ SHOCK-S User Manual

Frequency: 319.5MHz
Battery: 3V lithium CR123A
Magnet gap: 1 inch max
Operating Temperature: 32°-110°F (0°-45°C)
Operating Humidity: 5-85% RH non-condensing
Compatible with Qolsys control panels
Supervisory signal interval: 60 min (approximately)
Potentiometer: Shock sensitivity adjustment
✓
Exterior Doors
✓
Sliding
glass
doors
Windows
✓
✓
✓
IQ SHOCK-S QUICK INSTALL GUIDE
CHOOSE
INSTALLATION
LOCATION
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
Three dip switches allow you to customize the behavior of this device:
STEP
2
DIP!
SWITCH
CONFIGURATION
SPECIFICATIONS
STEP
1
DS#1 - Test Mode:
Enables sensitivity test
mode. !
Please note, when test mode is
enabled (ON) the IQ Shock will
NOT transmit signals to the IQ
Panel. This mode is only used
for initial installation of the
shock sensor.
ON:
OFF:
Disables sensitivity
test mode.
DS#2 - Pre-Warn:
ON:
Enables pre-warn
sounder and red LED.
OFF:
Disables pre-warn
sounder and red LED.
DS#3 - Reed Switch:
ON:
OFF:
Enables reed switch.
Disables reed switch.
ON
1
2
3
MAX
MIN
SENSOR
MAGNET
TAMPER
SWITCH
POTENTIOMETER
SHOCK
SENSOR
DIP
SWITCHES
LED
BUZZER
BATTERY
IMPORTANT NOTE:!
The IQ Shock is intended to be installed on doors with or without glass inserts and
on window frames but not on the actual glass surface.

QOLSYS IQ SHOCK-S Specifications

General

Type	Shock Sensor
Battery	CR2032
Wireless Frequency	319.5 MHz
Battery Life	Up to 5 years
Tamper Protection	Yes
Environmental Rating	Indoor Use Only
Compatibility	Qolsys IQ Panel 2+
Power Source	3V Lithium Battery
Mounting	Adhesive
Operating Temperature	32°F to 120°F

Summary

IQ SHOCK-S Quick Install Guide

Choose Installation Location

Select the optimal placement for the IQ Shock sensor on doors or windows.

Dip Switch Configuration

Customize device behavior using the three dip switches for specific functions.

IQ SHOCK-S Installation Steps

Device Casing, Battery, and Sensor Mounting

Open the device, pull the battery tab, and secure the sensor and magnet components.

Learn Into Panel and Sensitivity Adjustment

Add the device to the panel and fine-tune shock sensitivity for optimal performance.