QOLSYS QS-1100-P01 User Manual

STEP
1
IQ DOOR/WINDOW QUICK INSTALL GUIDE
✓
Exterior Doors
✓
Sliding
glass
doors
Windows
✓
CHOOSE
INSTALLATION
LOCATION
Also great for:
Medicine cabinets
Gun safes
Garage doors
Interior doors
Sensor: 3.25”H x 1.3”W x 1”D (8x3x1.5 cm)
Magnet: 1.3”H x 0.435”W x 0.312”D (3.3 x 1.1 x 0.79 cm)
Wireless signal range: 600ft (200M), open air.
Code outputs: tamper, tamper restore, alarm (primary
open), alarm restore (primary close), external alarm
(secondary wired open), external restore (secondary wired
closed), low battery.
Transmitter frequency: 319.5 MHz
Unique code ID
Supervisory keep-alive interval: 70 minutes.
RF Peak field strength: typical 36000 uV/m at 3m
Operating Temperature: -10C~50C
Relative Humidity: 5-95% Non-Condensing
Storage Temperature: -40-80C
Replace battery with exact replacement every 5 years
with 3V CR2032 Lithium (x2).
SPECIFICATIONS
SEE REVERSE FOR REMAINING STEPS
This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)

QOLSYS QS-1100-P01 Specifications

General

Model	QS-1100-P01
Battery Life	5 years
Type	Sensor
Compatibility	Qolsys IQ Panel
Wireless Frequency	915 MHz
Frequency	915 MHz
Battery Type	CR123A

Summary

IQ Door/Window Quick Install Guide

Installation Location Selection

Guide for selecting optimal placement for the door/window sensor and its applications.

Product Specifications

Detailed technical parameters including dimensions, range, frequency, and environmental ratings.

IQ Door/Window Installation Steps

Device Casing and Battery Preparation

Procedures for opening the sensor and removing battery tabs.

Mounting and Securing Sensor & Magnet

Instructions for selecting mounting hardware and physically attaching the sensor and magnet.

Panel Learning and Support

Steps to integrate the sensor into the panel and contact for technical assistance.