To Next Page

To Previous Page

QRS PNO

User Guide

QRS Music Technologies, Inc.

Technical Support - 800-247-6557

www.qrsmusic.com

The QRS PNOmation system ships with a NETGEAR EX6100 set to AP (as an Access Point). In order to play

all content available, receive auto updates, maximize ease of use and your investment, we recommend the

player system be set up as an extension of your homes network (network mode). To do this there are three

steps

1. Congure NETGEAR to extend your home network: Unplug the NETGEAR from the system, reset it and

congure it to extend your homes network as you would if you purchased the product separately. Ref

NETGEAR manual (steps we use are below)

 Unplug the NETGEAR from the PNOmation system and ip the switch on the side to Extender

 Plug into a wall outlet convenient to you and close to your router

 You will need

 Your network password (Case Sensitive)

 Wi-Fi device

 A paperclip to do a factory reset

 Reset the NETGEAR using the paperclip (hold until power light ashes 3 times and restarts unit)

 Log into Wi-Fi Network NETGEAR EX6100_2GExt once connected a network Geni should

appear

 In the Geni—Select your homes network—continue

 Enter your password– continue

 Select Skip for the 5G setup

 Select Private Network—continue

 Select Continue on the next setup page

 Select Ok on the pop up box - Wait for reboot— Verify connections with device LEDs -Done

1. Put your piano in Network mode - so it is set to receive an IP address from your router (“Shift” “B” on

your remote, or hold button 3 on the processor down for 4sec)

2. Plug the NETGEAR back to where it was prior to unplugging. Log into your homes network and use the

QRSFinder App from the App Store or Play Store - to open the system. Voice Prompts will also tell you

NETGEAR EX6100 WI-FI EXTENDER (AC750)

Brief How To

QRS 80308s User Manual

Questions and Answers: