QRS PNO
3
User Guide
QRS Music Technologies, Inc.
Technical Support - 800-247-6557
www.qrsmusic.com
1 2 3 4 5 6
Power/Status 1
Green Solid Power to the solenoid rail is on, the high power light on the
power supply is on, system is ready to be played.
Green Blink MIDI Control Data is being sent to the piano as a PWM signal.
The piano should be playing.
Amber Solid The piano is in Stand By Mode, power to the solenoid rail is o,
the high power light on the power supply is o, the piano is
awaiting a signal to wake up before playing.
Amber Blink NA
Red Solid There is a Key Solenoid or Pedal Solenoid Over-Current status
which will shut the high power to the system down.
Red Blink NA
System Activity 2
Green Solid The Pin Light Port Extender (PLx) has initialized, the controller
under the piano has successfully initialized, and the low power
light is on the power supply.
Green Blink NA
Amber Solid NA
Amber Blink The light will wink at you if the system is receiving an IR control
signal.
Red Solid There is a power issue/failure on the solenoid rail.
Red Blink There is a power issue/failure on the pedal solenoid.
Network Status 3
Green Solid The system is in Stand-Alone Mode, which means it is acting as
a router (hands out IP addresses) and belongs to its own
network (QRSPNOxxx)
Green/ Red
Blink
The system is setup to be in Stand-Alone Mode but there is no
network device or cable connected.
Amber Solid The system is in Network Mode, which means it is acting as a
node on an existing network (typically your homes). In this case
the home router will assign an IP address to the PNO3 system.
Amber/Red
Blink
The system is in Network Mode but there is no network device
or cable connected
Pin Light Port Extender (PLx) LED Light Status and Start Up
7
To Next Page
Loading...
Need help?
General
