QRS PNO
3
User Guide
QRS Music Technologies, Inc.
Technical Support - 800-247-6557
www.qrsmusic.com
Both PNO
3
AND the Piano’s Wi-Fi device must be programmed to change modes.
Stand Alone
Mode:
192.168.1.1
NOT connected to the Internet.
PNO
3
is its own wireless network QRSPNO_2GEXT.
PNO
3
hands out IP addresses to your devices that are logged into it, Android, IOS...
PNO
3
delivers control for Android, Google Chrome or Safari web browsers.
Connect to PNO3 by entering 192.168.1.1 in the address bar of the web browser.
How to Congure Stand Alone Mode
Using the Net gear Extender EX6100 / AC750 [iPad Example]
Netgear EX6100/AC750
PNO3 Stand Alone mode programming Steps
1. Flip the “Access Point/Extender” switch to the
“Access Point” position.
2. Plug the Extender into an outlet - wait for the
Power LED to turn green.
3. Use a paper clip to Press and Hold the “Factory
Reset” Button until power light ashes 3 times
(~10s)
4. The reset EX6100 will broadcast two SSID names;
EX6100_Netgear...2GEXT & 5GEXT (You may
want to turn the Wi-Fi OFF and then ON to refresh
the Wi-Fi list.)
5. Go to your device’s Wi-Fi settings and Select
“EX6100_Netgear_2GEXT”.
6. The Netgear “genie” should appear within one
minute. Or, go to your web browser - Safari or
Chrome & enter: www.mywiext.net
7. A splash screen will appear stating device is set
to Access point, wait a moment and Congura-
tion Screen will appear
8. Select “No” on the conguration screen, then the
“Next” button, A pop up asking you to conrm
manual setup. Select OK
9. Authentication Required Pop Up will appear
Enter username: “admin“ and “password” as the
Password then select “Log In” button.
1
3
15
To Next Page
Loading...
Need help?
General
