BT-Q1000 Super 51-CH Performance GPS Travel Recorder
8
- Charging your battery
For the first time using the BT-Q1000, please charge
battery until it is fully charged. Take the power cable
and connect it to the power jack (mini USB type) and
recharge through USB cable, travel charger, or car
cigarette adaptor. This will begin to charge the battery.
Charging time is 3 hours typically.
- When the Power LED is Red, battery power is low status. Please recharge.
- When the Power LED is Green, the battery is under charging mode.
- When the Power LED is blinking, the battery is fully charged.
5-4. LED Indicators
LED Status Flash ON OFF
Power
(Red/Green)
Low Power (Red)
Fully charged (Green)
Recharging
(Green)
Bluetooth
(Blue)
Flash per 2 sec.: Bluetooth
connected and transmitting
Mode
Flash per 5 sec.
: Power
saving mode
Not
connected
/Pairing
GPS not
powered
GPS
(Orange)
Flash per 1 sec.(Orange):
GPS position is fixed,
Navigation
Flash 3 times (Blue)
:
POI(Point of Interest) is
recorded
Detecting
Satellite, GPS
position not
fix
GPS not
powered
To Next Page
Loading...
Need help?
General
