QTech QSW-2800 series - Page 155

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
141
no spanning-tree mode
Port Mode
spanning-tree mcheck
Force port migrate to run under MSTP.
2. Configure instance parameters
Command
Explanation
Global Mode
spanning-tree mst <instance-id> priority
<bridge-priority>
no spanning-tree mst <instance-id>
priority
Set bridge priority for specified instance.
spanning-tree priority <bridge-priority>
no spanning-tree priority
Configure the spanning-tree priority of the
switch.
Port Mode
spanning-tree mst <instance-id> cost
<cost>
no spanning-tree mst <instance-id> cost
Set port path cost for specified instance.
spanning-tree mst <instance-id> port-
priority <port-priority>
no spanning-tree mst <instance-id> port-
priority
Set port priority for specified instance.
spanning-tree mst <instance-id>
rootguard
no spanning-tree mst <instance-id>
rootguard
Configure currently port whether running
rootguard in specified instance, configure the
rootguard port can’t turn to root port.
spanning-tree rootguard
no spanning-tree rootguard
Configure currently port whether running
rootguard in instance 0, configure the
rootguard port can’t turn to root port.
spanning-tree [mst <instance-id>]
loopguard
no spanning-tree [mst <instance-id>]
loopguard
Enable loopguard function on specified
instance, the no command disables this
function.
3. Configure MSTP region parameters
Command
Explanation
Global Mode
spanning-tree mst configuration
no spanning-tree mst configuration
Enter MSTP region mode. The no
command restores the default setting.
MSTP region mode