QTech QSW-2800 series - Page 215

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
201
Command
Explanation
Global Mode
service dhcpv6
no service dhcpv6
To enable DHCPv6 service.
2. To configure DHCPv6 address pool
(1) To achieve/delete DHCPv6 address pool
Command
Explanation
Global Mode
ipv6 dhcp pool <poolname>
no ipv6 dhcp pool <poolname>
To configure DHCPv6 address pool.
(2) To configure parameter of DHCPv6 address pool
Command
Explanation
DHCPv6 address pool Configuration Mode
network-address <ipv6-pool-start-
address> {<ipv6-pool-end-address> |
<prefix-length>} [eui-64]
no network-address
To configure the range of IPv6 address
assignable of address pool.
dns-server <ipv6-address>
no dns-server <ipv6-address>
To configure DNS server address for DHCPv6
client.
domain-name <domain-name>
no domain-name <domain-name>
To configure DHCPv6 client domain name.
excluded-address <ipv6-address>
no excluded-address <ipv6-address>
To exclude IPv6 address which isn’t used for
dynamic assignment in address pool.
lifetime {<valid-time> | infinity}
{<preferred-time> | infinity}
no lifetime
To configure valid time or preferred time of
DHCPv6 address pool.
3. To enable DHCPv6 server function on port.
Command
Explanation
Interface Configuration Mode
ipv6 dhcp server <poolname>
[preference <value>] [rapid-commit]
[allow-hint]
no ipv6 dhcp server <poolname>
To enable DHCPv6 server function on specified
port, and binding the used DHCPv6 address
pool.