QTech QSW-2800 series - Page 292

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
278
Switch#show firewall
Firewall Status: Enable.
Firewall Default Rule: Permit.
Switch#show ipv6 access-lists
Ipv6 access-list 600(used 1 time(s))
ipv6 access-list 600 deny 2003:1:1:1::0/64 any-source
ipv6 access-list 600 permit 2003:1:1:1:66::0/80 any-source
Switch #show access-group interface ethernet 1/10
interface name:Ethernet1/10
IPv6 Ingress access-list used is 600, traffic-statistics Disable.
Scenario 5:
The configuration requirement is stated as below: The interface 1, 2, 5, 7 belongs to vlan100,
Hosts with 192.168.0.1 as its IP address should be disabled from accessing the listed
interfaces.
Configuration description:
Create the corresponding access list.
Configure datagram filtering.
Bind the ACL to the related interface.
The configuration steps are listed as below.
Switch (config)#firewall enable
Switch (config)#vlan 100
Switch (Config-Vlan100)#switchport interface ethernet 1/1;2;5;7
Switch (Config-Vlan100)#exit
Switch (config)#access-list 1 deny host-source 192.168.0.1
Switch (config)#interface ethernet1/1;2;5;7
Switch (config-if-port-range)#ip access-group 1 in
Switch (Config-if-Vlan100)#exit
Configuration result:
Switch (config)#show access-group interface vlan 100
Interface VLAN 100:
Ethernet1/1: IP Ingress access-list used is 1, traffic-statistics Disable.
Ethernet1/2: IP Ingress access-list used is 1, traffic-statistics Disable.
Ethernet1/5: IP Ingress access-list used is 1, traffic-statistics Disable.
Ethernet1/7: IP Ingress access-list used is 1, traffic-statistics Disable.