QTech QSW-2800 series - Page 31

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
17
addr>
no authentication securityipv6 <ipv6-
addr>
switch through Telnet; the no command deletes
the authorized Telnet security address.
authentication ip access-class
{<num-std>|<name>}
no authentication ip access-class
Binding standard IP ACL protocol to login with
Telnet/SSH/Web; the no form command will
cancel the binding ACL.
authentication ipv6 access-class
{<num-std>|<name>}
no authentication ipv6 access-class
Binding standard IPv6 ACL protocol to login with
Telnet/SSH/Web; the no form command will
cancel the binding ACL.
authentication line {console | vty |
web} login method1 [method2 …]
no authentication line {console | vty |
web} login
Configure authentication method list with telnet.
authentication enable method1
[method2 …]
no authentication enable
Configure the enable authentication method list.
authorization line {console | vty |
web} exec method1 [method2 …]
no authorization line {console | vty |
web} exec
Configure the authorization method list with
telnet.
accounting line {console | vty}
command <1-15> {start-stop | stop-
only | none} method1 [method2…]
no accounting line {console | vty}
command <1-15>
Configure the accounting method list.
Admin Mode
terminal monitor
terminal no monitor
Display debug information for Telnet client login to
the switch; the no command disables the debug
information.
2. Telnet to a remote host from the switch
Command
Explanation
Admin Mode
telnet [vrf <vrf-name>] {<ip-addr> |
<ipv6-addr> | host <hostname>}
[<port>]
Login to a remote host with the Telnet client
included in the switch.