QTech QSW-2800 series User Manual

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
312
<IPaddress>
authentication server.
3. Configure the TACACS+ authentication timeout time
Command
Explanation
Global Mode
tacacs-server timeout <seconds>
no tacacs-server timeout
Configure the authentication timeout for the
TACACS+ server, the “no tacacs-server
timeout” command restores the default
configuration.
4. Configure the IP address of the TACACS+ NAS
Command
Explanation
Global Mode
tacacs-server nas-ipv4 <ip-address>
no tacacs-server nas-ipv4
To configure the source IP address for the
TACACS+ packets for the switch.
42.3 TACACS+ Scenarios Typical
Examples
TACACS Configuration
A computer connects to a switch, of which the IP address is 10.1.1.2 and connected with a
TACACS+ authentication server; IP address of the server is 10.1.1.3 and the authentication
port is defaulted at 49, set telnet log on authentication of the switch as tacacs local, via using
TACACS+ authentication server to achieve telnet user authentication.
Switch(config)#interface vlan 1
10.1.1.1
10.1.1.2
Tacacs
Server
10.1.1.3

QTech QSW-2800 series Specifications

General

Brand	QTech
Model	QSW-2800 series
Category	Switch
Language	English