+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
Configuration on the switch:
Switch(config)# ip http secure-server
Switch(config)# ip http secure-port 1025
Switch(config)# ip http secure-ciphersuite rc4-128-sha
44.4 SSL Troubleshooting
In configuring and using SSL, the SSL function may fail due to reasons such as physical
connection failure or wrong configurations. The user should ensure the following:
First good condition of the physical connection;
Second all interface and link protocols are in the UP state (use “show interface” command);
Then, make sure SSL function is enabled (use ip http secure-server command );
Don’t use the default port number if configured port number, pay attention to the port number
when input the web wide;
If SSL is enabled, SSL should be restarted after changes on the port configuration and
encryption configuration;
IE 7.0 or above should be used for use of des-cbc-sha;
If the SSL problems remain unsolved after above try, please use debug SSL and other
debugging command and copy the DEBUG message within 3 minutes, send the recorded
message to technical server center of our company.
To Next Page
Loading...
Need help?
General
