QTech QSW-2800 series User Manual

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
383
56.2 Typical Examples of SNTP
Configuration
Typical SNTP Configuration
All switches in the autonomous zone are required to perform time synchronization, which is
done through two redundant SNTP/NTP servers. For time to be synchronized, the network
must be properly configured. There should be reachable route between any switch and the two
SNTP/NTP servers.
Example: Assume the IP addresses of the SNTP/NTP servers are 10.1.1.1 and 20.1.1.1,
respectively, and SNTP/NTP server function (such as NTP master) is enabled, then
configurations for any switch should like the following:
Switch#config
Switch(config)#sntp server 10.1.1.1
SWITCH
… …
SWITCH
SWITCH
SNTP/NTP
SERVER
SNTP/NTP
SERVER

QTech QSW-2800 series Specifications

General

Brand	QTech
Model	QSW-2800 series
Category	Switch
Language	English