QTech QSW-2800 series User Manual

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
387
debug ntp adjust
no debug ntp adjust
To enable debug switch of time update
information.
debug ntp sync
no debug ntp sync
To enable debug switch of time synchronize
information.
debug ntp events
no debug ntp events
To enable debug switch of NTP event
information.
57.3 Typical Examples of NTP
Function
A client switch wanted to synchronize time with time server in network, there is two time server
in network, the one is used as host, the other is used as standby, the connection and
configuration as follows (Switch A and Switch B are the switch or route which support NTP
server ):
The configuration of Switch C is as follows: (Switch A and Switch B may have the different
command because of different companies, we not explain there, our switches are not support
NTP server at present)
Switch C:
Switch(config)#ntp enable
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip address 192.168.1.12 255.255.255.0
Switch(config)#interface vlan 2
Switch(Config-if-Vlan1)#ip address 192.168.2.12 255.255.255.0
Switch(config)#ntp server 192.168.1.11
Switch(config)#ntp server 192.168.2.11

QTech QSW-2800 series Specifications

General

Brand	QTech
Model	QSW-2800 series
Category	Switch
Language	English