QTech QSW-2800 series User Manual

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
396
5. Display executed-commands state
Display and clear log buffer zone
Command
Description
Admin Mode
show logging buffered [ level {critical | warnings} |
range <begin-index> <end-index>]
Show detailed log information in the
log buffer channel.
clear logging sdram
Clear log buffer zone information.
Configure the log host output channel
Command
Description
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility <local-
number> ] [level <severity>]
no logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number>]
Enable the output channel of the log
host. The “no” form of this command
will disable the output at the output
channel of the log host.
logging loghost sequence-number
no logging loghost sequence-number
Add the loghost sequence-number
for the log, the no command does not
include the loghost sequence-
number.
Enable/disable the log executed-commands
Display the log source
Command
Description
Global mode
logging executed-commands {enable | disable}
Enable or disable the logging
executed-commands
Command
Description
Admin and configuration mode
show logging source mstp
Show the log information source of
MSTP module.

QTech QSW-2800 series Specifications

General

Brand	QTech
Model	QSW-2800 series
Category	Switch
Language	English