QTech QSW-2800 series - Page 60

+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
46
Global Mode
interface ethernet <interface-list>
Enters the network port configuration mode.
2. Configure the properties for the Ethernet ports
Command
Explanation
Port Mode
combo-forced-mode {copper-forced |
copper-preferred-auto | sfp-forced |
sfp-preferred-auto}
Sets the combo port mode (combo ports only).
shutdown
no shutdown
Enables/Disables specified ports.
name <string>
no name
Names or cancels the name of specified ports.
mdi {auto | across | normal}
no mdi
Sets the cable type for the specified port; this
command is not supported by combo port and
fiber port of switch.
speed-duplex {auto [10 [100 [1000]]
[auto | full | half |]] | force10-half |
force10-full | force100-half | force100-
full | force100-fx [module-type {auto-
detected | no-phy-integrated | phy-
integrated}] | {{force1g-half | force1g-
full} [nonegotiate [master | slave]]}|
force10g-full}
no speed-duplex
Sets port speed and duplex mode of
100/1000Base-TX or 100Base-FX ports. The no
format of this command restores the default
setting, i.e., negotiates speed and duplex mode
automatically.
negotiation {on|off}
Enables/Disables the auto-negotiation function
of 1000Base-FX ports.
bandwidth control <bandwidth> [both
| receive | transmit]
no bandwidth control
Sets or cancels the bandwidth used for
incoming/outgoing traffic for specified ports.
flow control
no flow control
Enables/Disables traffic control function for
specified ports.
loopback
no loopback
Enables/Disables loopback test function for
specified ports.
rate-suppression {dlf | broadcast |
multicast} <Kbits>
Enables the storm control function for
broadcasts, multicasts and unicasts with
unknown destinations (short for broadcast), and
sets the allowed broadcast packet number; the
no format of this command disables the