+7(495) 797-3311 www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
Ensuring SNMP configuration is correct, or else errored event can not be reported to network
management system.
Link does not normally communicate in OAM loopback mode, it should cancel remote
loopback in time after detect the link performance.
Ensuring the used board supports remote loopback function.
Port should not configure STP, MRPP, ULPP, Flow Control, loopback detection functions after
it enables OAM loopback function, because OAM remote loopback function and these
functions are mutually exclusive.
To Next Page
Loading...
Need help?
General
