Need help?Do you have a question about the Quad Electroacoustics QUAD 405 and is the answer not in the manual?
General| Weight | 8.5 kg |
|---|---|
| Type | Power Amplifier |
| Power Output | 100 W per channel |
| Input Sensitivity | 0.5V |
| Signal-to-Noise Ratio | 100 dB |
| Speaker Load Impedance | 4Ω - 16Ω |
Original configuration of the amplifier board.
Modification to the copper track layout.
Component changes and copper track reduction.
Introduction of the clamp circuit for output protection.
Modification of copper pads for production.
Features clamp circuit and ESL voltage limiter.
Details specific to the QUAD 405-2 PCB version.
Lists alternative components for transistors and LEDs.
To Next Page