8. Place an envelope into the print area towards the back right corner. The unit will
perform a test print.When the process is complete remove the envelope .
You may have to carry this test out several times to align the head correctly.
9. Continue the test until “F” is the straightest Line
When the process is finished press:
10.
The swap process is now complete. Press:
Please power the unit off then on before processing mail.
This will save any settings in the system.
Please call us at 1-800-661-0200 if you require assistance.
16
| Page 16 | Jun-16-2015 01:33 | Swap mailing system base unit
1
To Next Page
Loading...
Need help?
General
