9. Place the new unit onto its back to access the meter cover. Open the cover and refit
the meter as shown. If the cover does not close properly, the meter is not fitted
correctly.
10. Turn the unit back to the upright position. Refit the weight platform by connecting the
plug as shown and placing the platform back on top of the base unit.
11. If you use LAN :
Reconnect the LAN to the port as shown in the following diagram.
Check that the LAN cable is also connected to the correct socket on the wall.
4
| Page 4 | Jun-16-2015 01:33 | Swap mailing system base unit
1
To Next Page
Loading...
Need help?
General
