To Next Page

To Previous Page

Customer Helpline 01904 727500

www.gardenservicecentre.co.uk

Maintenance

Cleaning or Replacing Spark Plug

2a Once the engine has cooled, pull off the spark plug boot with a twist. Remove the spark plug

using the socket spanner supplied.

2b Clean the plug with a wire brush.

2c Using a feeler gauge set the gap to 0.51mm.

2d Install the spark plug carefully by hand, to avoid cross-threading.

2e After the spark plug is seated, tighten with the spanner to compress the washer.

Cleaning or Replacing Air Filter

WARNING! Never run the engine without the air lter element installed.

1. Loosen the fastener that holds the cover.

2. Open the cover and remove the lter.

3. To loosen debris, gently tap the lter on a hard surface. If the lter is excessively dirty, replace

with a new lter.

4. Install the lter.

5. Install the cover tabs into the slots.

6. Close the cover and secure with the fastener.

0.43~0.58 2c

Qualcast XSS41D User Manual

Questions and Answers: