17
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
List of consumable Qualcast parts
Parts can be ordered via www.gardenservicecentre.co.uk
QC12YC Spark plug 932217 Blade bolt
916901 Collection grass bag 466018 Fixing knob
933206 Blade
Maintenance
1. Tip the machine slightly towards the oil ller pipe and reach under the deck.
2. Hold the blade and unscrew the blade bolt counterclockwise using a spanner wrench. Remove
the washer and the blade.
3. Inspect the blade adaptor on any signs of damage.
4. Fit a new blade, locate the blade on the two studs on the blade ange and then replace the
washer and bolts.
5. Check the washer is still slightly domed to keep the pressure on the bold to stop it unwinding,
keeping the blade rmly secure. Then replace the washer (right way around!) and bolts.
6. Make sure the blade is correctly located, and then rmly tighten the bolt. Do not over tighten. The
up turn of the blade must project into the motor compartment.
NOTE! If you are unsure about performing this operation call our helpline or go to an authorised
dealer to change the blade for you. .
Replacing Cutting Blade (continued)
To Next Page
Loading...
