Qualcast XSS41D User Manual

18
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Troubleshooting
General Troubleshooting
WARNING!
- Always switch off the engine and pull the ignition cable before starting any inspection or
adjustment work.
- If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember
that the exhaust and other parts will get hot.
Fault Possible Cause Solution
Loud while running,
machine vibrates heavily
- Screws are loose
- Blade fasteners are loose
- Blade is unbalanced
- Check screws
- Check blade fasteners
- Replace blade
Engine does not start - start/stop bar not pressed
- Primer bulb is empty
- Spark plug is defective
- Fuel tank is empty
- Engine may be ooded
- Press start/stop bar
- Press primer bulb 3~5 times.
- Replace spark plug
- Rell with fuel
- remove plug and dry, see
page 15
Engine runs unsteadily - Air lter is soiled
- Spark plug is soiled
- Clean the air lter
- Clean the spark plug
Uneven mowing results - Blade is blunt
- Cutting height is too low
- Sharpen the blade
- Set correct height
Unsatisfactory grass
collection
- Cutting height is too low
- Blade is worn
- grass bag is clogged
- Set correct height
- Replace the blade
- Empty the grass bag
The following table provides solutions to common problems encountered with the lawnmower.

Qualcast XSS41D Specifications

General

Brand	Qualcast
Model	XSS41D
Category	Lawn Mower
Language	English