Configuring Wireless Network
Quantum Spark 1500, 1600 and 1800 Appliance Series R80.20.40 Locally Managed Administration Guide | 73
Wireless Network tab
Interface Connection
Assigned to - Select Separate network or one of the existing configured networks. When selecting a
separate network configure this information:
n
IP address - IPv4 and IPv6 addresses
n
Subnet mask - for IPv4 addresses
n
Prefix length - for IPv6 addresses
DHCPv4 Server
Select one of the options:
n
Enabled - Enter the IP address range and if necessary the IP address exclude range. The
appliance's own IP address is automatically excluded from this range. You can also exclude or
reserve specific IP addresses by defining network objects in the Users & Objects > Network Objects
page. Reserving specific IP addresses requires the MAC address of the device.
n
Relay - Enter the DHCP server IP address.
n
Disabled
IPv6 Auto Assignment
Select one of the options:
n
SLAAC (Stateless Address Autoconfiguration)
n
DHCPv6 Server - Enter the IP address range and the IP addresses exclude range
n
DHCPv6 Server Relay - Enter the DHCPv6 server IP address and the Secondary DHCPv6 server IP
address
Access Policy tab
These options create automatic rules that are shown in the Access Policy > Firewall Policy page.
n
Allow access from this network to local networks (Wireless network is trusted)
n
Log traffic from this network to local networks
Advanced tab
Click the checkbox to exclude from DNS proxy.
Advanced IPv6 Settings
Configure the Router Advisement fields.
DHCP\SLAAC Settings tab
Note - In IPv4-only mode, this tab is called DHCPv4 Settings.
The values for the DHCP options configured on this tab will be distributed by the DHCP server to the DHCP
clients.
DNS Server Settings (For DHCPv6/SLAAC)
Select one of these options:
n
Auto - Use the DNS configuration of the device
n
Use the following IP addresses - Enter the first, second and third DNS servers
To Next Page
Loading...
Need help?
General
