Chapter 9: Configuration
VTL Configuration
Quantum DXi4700 User’s Guide 218
Figure 139: Media Actions Page
To perform actions on virtual tape cartridges:
1. In the Partition drop-down box, select the partition that contains the cartridges to work with.
Note: Select UNASSIGNED to work with cartridges that are not assigned to any partition.
The table displays the following information for all virtual tape cartridges in the partition:
Barcode The barcode number of the cartridge.
Type The cartridge type (LTO or SDLT).
Partition The partition where the cartridge is located.
WP The write protect status of the cartridge (Write Enabled or Write Protected).
To Next Page
Loading...
