Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide 297
Data Select to allow data traffic.
Any Select to allow all types of traffic (management, replication, and data).
Additional Information
l At least one interface must allow management traffic.
l If the DXi is configured for source or target replication, you should configure at least one interface
to allow replication traffic (select Repl or Any) before applying changes to network settings.
l If you configure segmentation for non-bonded interfaces (Ethernet ports) that are on the same
subnet, all traffic will use the lowest numbered Ethernet port first, no matter how segmentation is
configured. To avoid this issue, create bonded interfaces, and then select the desired traffic type
for each bonded interface.
7. Click Update to save the changes you made to the IP Address table. (Clicking Update does not yet
apply the new network settings to the DXi4700.)
8. Click Delete to remove IP address information for the selected interface. Or click Undo to revert all
current IP Address Table changes to the last update.
Note: When you add a network interface, a default route (via the default gateway) is automatically
created for the interface after network settings are applied and the DXi reboots. For example, if you add
an interface with IP address 10.20.185.172, a route with the destination IP address 10.20.185.0 is
automatically added. If you delete the default route, it is automatically added again the next time
network settings are applied and the DXi reboots. For more information about interface routing, see
Network on page 290.
Configuring Interface Routing
Some network configurations require that you specify routing details for an interface. You need to specify
routing details if the host or client the interface connects to is on a different subnet that is not reachable using
the default gateway. You also need to specify routing details if you have configured multiple network
segments (replication, data, or management) on the same subnet. For more information and examples, see
Network on page 290.
Under IP Address Configuration > Routing Details, enter routing information for one or more interfaces
(see Figure 186 on the next page):
To Next Page
Loading...
