Quantum DXi4700

Chapter 9: Configuration
System
Quantum DXi4700 User’s Guide 306
Accessing Remote Management on page 57).
1. Under GUI Administrator enter the following information:
Old Password Enter the old password.
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
l Disabling the GUI Administrator - You cannot disable this account unless LDAP/AD is enabled. In
addition, you must also be logged in to the system as an LDAP/AD user (see LDAP/AD on the
next page).
l Passwords can be up to 32 characters. Alphanumeric characters and special characters are
allowed.
l Loss of this password will require Quantum service support.
2. Click Apply.
Enabling GUI Monitor Account
Use the GUI password when logging onto the remote management console as a monitor (see Accessing
Remote Management on page 57).
1. Under GUI Monitor do one of the following steps:
l Select the Enable account check box to enable the GUI monitor account.
l Clear the Enable account check box to disable the GUI monitor account.
2. Enter the following information:
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
Passwords can be up to 32 characters. Alphanumeric characters and special characters are
allowed.
3. Click Apply.