Quantum DXi4700

Chapter 2: Basic Operations
DXi4700 Node
Quantum DXi4700 User’s Guide 38
Item Indicator, Button, or
Connector
Icon Description
5 VGA connector
Caution: Use of connected peripheral devices, such as a
USB keyboard and mouse or a VGA display, is not supported
and may cause incorrect system operation.
6 USB 2.0 connector
Caution: Use of connected peripheral devices, such as a
USB keyboard and mouse or a VGA display, is not supported
and may cause incorrect system operation.
7 Information tag A slide-out label panel which displays the system serial number.
8 System identification
button
Press to toggle the system ID on and off. The identification
buttons on the front and rear panels can be used to locate a
particular system within a rack. When one of these buttons is
pressed, the system status indicator on the rear flashes until one
of the buttons is pressed again. 뼀 뾿
Table 2: DXi4700 Node - Diagnostic Indicators
Indicator Icon Condition Recommended Action
Health Solid blue - The system is on and in
good health.
Blinking amber - The system is on
and an error exists.
See General Troubleshooting on
page 379.
Hard drive Blinking amber - A hard drive error
has occurred
See Hardware Problems on
page 380.
Electrical Blinking amber - An electrical error
has occurred.
See Hardware Problems on
page 380.
Temperature Blinking amber - A thermal error
has occurred.
See Temperature Problems on
page 383.
Memory Blinking amber - A memory error
has occurred.
See General Troubleshooting on
page 379.
PCIe Blinking amber - A PCIe card error
has occurred.
See General Troubleshooting on
page 379.