Quantum DXi6900

Performing Initial Configuration
Quantum DXi6900 Installation Guide 66
l IP Address - The IP address of the DXi6900.
l Netmask - The network mask of the DXi6900.
l Gateway - The gateway of the DXi6900. (This is usually not the same as the default gateway.)
c. Select the Any check box to allow all traffic types (management, replication, and data) on the
interface.
d. Click Update to save the changes you made to the IP Address table.
12. Do not make any changes under IP Address Configuration > Routing Details unless directed by
your network administrator.
Note: If the DXi needs to communicate with another subnet that is not reachable using the default
gateway, a route must be added under the Routing Details section. (For more information about
interface routing, see the “Network” section in the Quantum DXi6900 User’s Guide, 6-68159).
13. Click Next to continue.
The Date & Time page displays (see Figure 55 below).
Figure 55: Getting Started Wizard: Date & Time
14. If necessary, select Manual Date & Time Settings to manually set the system date and time.
Specify the New System Date by clicking Calendar. Specify the New System Time using the drop-
down boxes.
Note: You can also choose to synchronize the system time with an NTP time server. To select a
timeserver pool, you must have specified at least one DNS IP address in step 5d above.
Otherwise, you must specify the IP address of the timeserver pool. For more information, see the
Quantum DXi6900 User’s Guide, 6-68159).