Quantum Superloader 3 - Checking Accessories

Unpacking the Autoloader 5
SuperLoader 3
Checking Accessories 0
The following accessories are shipped with the Quantum SuperLoader 3:
• Quantum SuperLoader 3 Quick Start Guide
• SCSI tape drive kits
• SCSI host or server cable
• SCSI terminator (not included with Serial Attached SCSI)
• Fibre Channel tape drive kits
• Fibre Channel cable
•Ethernet cable
• Hardware to rack mount the autoloader (see figure 1
)
• Four autoloader brackets (two long and two short to accommodate different rack
depths)
• Two support brackets
• Two sets (decimal and metric) of four support bracket 10-32 x 1/4 inch button
head screws (two per support bracket)
•TORX
®
L-Key drivers (T8 and T10)
• One magazine blank
•Power cable
• Documentation CD containing all of the documentation in Adobe
®
Portable
Document Format (PDF)
•Bar code labels
You will also need the following parts that were shipped with your rack:
• Eight clip nuts
• Eight rack screws
Figure 1 Rack Mount
Hardware
Short autoloader
brackets (72-A225-A)
Support brackets
(74-60605-01)
Long autoloader
brackets (72-A226-A)
Support bracket screws
72-A348-A (4) or 90-60227-50 (4)