③ Push [▲] or [▼] to select the desired pre-programmed individual address.
·The ID code for the position report call can be set in advance.
④ Push [DSC] to enter the standby condition for Position Report call.
·Channel 70 is selected and “READY” appears.
⑤ Push [DSC] to transmit the Position Report call.
⑥ After the Position Report call has been transmitted, stand by on Channel 70 until an
acknowledgement is received.
· “WAIT ACK” scrolls at the channel comment indicator.
⑦ Push any key to exit the condition and return to the normal operation.
◆ Receiving a Position Request call
While monitoring Channel 70 and a Position Request call is received:
① “DSC” appears and “RCV POS REQUEST” scrolls at the channel comment indicator.
② Push any key to stop the beep.
③Push [DSC] to reply to the call; Push any other key to ignore the call.
To Next Page
Loading...