QubicaAMF XLi Pinspotter Motor and Gearbox Manual
400-088-038 26 Revision F
3.3 Procedures
This section provides instructions for the initial setup of the back end gearboxes as well as procedures for
replacing the oil seals, changing the gearbox oil, detecting gearbox problems, and separating the gearbox
and motor.
The gearbox is made of aluminum and is fairly heavy. It is recommended that if the back end gearbox needs
to be removed, the back end motor should be removed before removing the gearbox.
3.3.1 Initial Setup
Back end gearboxes are shipped installed on the pinspotter. Check the oil level before putting into service.
The oil level has been verified before shipping and should not need to be adjusted.
Caution! Do not operate the gearbox with the solid pipe plug installed on the top of the gearbox.
Doing so can cause the gearbox to pressurize and leak!
Tool List
6mm Hex Wrench
17mm Combination Wrench
1. Remove the solid fill plug from the top of the gearbox. This was installed for shipping only. Do not
remove the plug washer.
2. The vent plug and installation directions are shipped in a clear plastic bag attached to the top of the
gearbox.
3. Install the vent plug, on top of the plug washer, in the threaded opening on top of the gearbox. Tighten
securely.
4. Repeat Steps 1 through 3 for the remaining back end gearboxes.
Vent Plug Location
To Next Page
Loading...