LTE Module Series
BG96 Hardware Design
BG96_Hardware_Design 23 / 78
General
purpose analog
to digital
converter
interface
If unused, keep this pin
open.
25, 51, 56,
57, 63, 65,
66, 76~78,
83~88,
92~99
Keep these pins
unconnected.
1. ā*ā means under development.
2.
1)
When PSM is enabled and then reboot the module, the function of PSM_IND pin will be activated.
This pin outputs a high level voltage when the module is in normal operation state, and outputs a low
level voltage when the module enters into PSM.
3. Keep all RESERVED pins and unused pins unconnected.
3.3. Operating Modes
The table below briefly summarizes the various operating modes referred in the following chapters.
Table 5: Overview of Operating Modes
Software is active. The module has registered on network, and it is
ready to send and receive data.
Network connection is ongoing. In this mode, the power consumption is
decided by network setting and data transfer rate.
BG96 module and the network may negotiate over non-access stratum signaling the use
of e-I-DRX for reducing power consumption, while being available for mobile terminating
data and/or network originated procedures within a certain delay dependent on the DRX
cycle value.
To Next Page
Loading...
