Quectel BG96 Series - RF Output Power

LTE Module Series
BG96 Hardware Design
BG96_Hardware_Design 60 / 78
1.
1)
Typical value with USB and UART disconnected.
2.
2)
Sleep state with UART connected and USB disconnected. The module can enter into sleep state
through executing AT+QSCLK=1 command via UART interface and then controlling the module’s
DTR pin. For details, please refer to Chapter 3.4.4.
3.
3)
Standby state with UART connected and USB disconnected.
Table 33: GNSS Current Consumption
Description
Conditions
Typ.
Unit
Searching
(AT+CFUN=0)
Cold Start @Passive Antenna
41.7
mA
Lost State @Passive Antenna
42
mA
Tracking
(AT+CFUN=0)
Instrument Environment
21.7
mA
Open Sky @Passive Antenna
TBD
mA
Open Sky @Active Antenna
TBD
mA
6.5. RF Output Power
The following table shows the RF output power of BG96 module.
Table 34: RF Output Power
Frequency
Max.
Min.
LTE-FDD B1/B2/B3/B4/B5/B8/B12/B13/B18/B19/B20/B26/B28
23dBm±2dB
<-39dBm
LTE-TDD B39
23dBm±2dB
<-39dBm
GSM850/GSM900
33dBm±2dB
5dBm±5dB
DCS1800/PCS1900
30dBm±2dB
0dBm±5dB
GSM850/GSM900 (8-PSK)
27dBm±3dB
5dBm±5dB
DCS1800/PCS1900 (8-PSK)
26dBm±3dB
0dBm±5dB
NOTES