Need help?Do you have a question about the Quectel BC26 and is the answer not in the manual?
General| Brand | Quectel |
|---|---|
| Model | BC26 |
| Category | Control Unit |
| Language | English |
Document revision history and changes.
Details the AT Command Set for Quectel NB-IoT BC26 module.
Explains the structure and format of AT commands.
Lists the character sets supported by the BC26 AT command interface.
Retrieves product identification details and software revision.
Controls whether AT commands are echoed back to the DTE.
Requests the manufacturer's identification information from the module.
Requests the manufacturer's model information from the module.
Requests the manufacturer's revision information from the module.
Retrieves detailed signal quality parameters like RSSI, RSRP, and RSRQ.
Requests various types of product serial numbers, including IMEI.
Manages and queries EPS network registration status and location information.
Provides the terminal's perceived radio connection status to the base station.
Selects and registers the network operator, including manual and automatic modes.
Attaches or detaches the module from the packet domain service.
Specifies PDP context parameter values for network connectivity.
Activates or deactivates specified PDP contexts for data services.
Retrieves the IP addresses assigned to the defined PDP contexts.
Requests the International Mobile Subscriber Identity (IMSI).
Selects the level of MT functionality, including power saving and resetting.
Configures the reporting of mobile termination errors using +CME ERROR codes.
Controls the UE's power saving mode (PSM) parameters.
Configures the Extended Discontinuous Reception (eDRX) parameters for power saving.
Reads dynamic eDRX parameters for the current cell.
Provides extended error reports for various communication failures.
Activates or deactivates a specified PDN context for network access.
Tests IP network connectivity using ICMP packets to a remote host.
Creates a TCP or UDP socket for network communication.
Binds a local address and port to a socket.
Connects a socket to a specified remote address and port.
Sends data to the network via a connected socket.
Disconnects an established socket connection.
Closes a socket, releasing associated resources.
Indicates when data has been received on a socket.
Indicates when an error has occurred with a socket connection.
Provides example usage scenarios for socket commands.
Queries the current operating band of the NB-IoT modem.
Resets the User Equipment (UE) module immediately.
Selects the scrambling algorithm for network communication.
Locks the UE to a specific frequency and optionally Cell ID.
Sets the NB-IoT release assistance indication for network interaction.
Enables an indication when the modem wakes up from deep sleep.
Queries current modem status, serving cell, and network information.
Creates an instance for communication with the NB-IoT OneNET platform.
Deletes an existing OneNET communication instance.
Adds a LWM2M object to the OneNET instance.
Deletes a LWM2M object from the OneNET instance.
Sends a login request to the OneNET platform.
Sends a logout request to the OneNET platform.
Responds to read requests from the application server.
Responds to write requests from the application server.
Responds to execute requests from the application server.
Responds to observe requests from the application server.
Notifies data to the application server or IoT platform.
Sends an update request to the OneNET platform.
Queries the current version of the OneNET protocol.
Provides definitions and abbreviations used in the document.
To Next Page
