Quectel BC26 - Network Commands - Socket; AT+QSOC Create a TCP;UDP Socket

NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 48 / 73
5 Network Commands – Socket
The AT command names listed below are temporary, and may be changed in the future release.
5.1. AT+QSOC Create a TCP/UDP Socket
This command creates a TCP or UDP socket.
Parameter
AT+QSOC Create a TCP/UDP Socket
Write Command
AT+QSOC=<domain>,<type>,<protoc
ol>[,<cid>]
Response
+QSOC=<socket_id>
OK
If there is any error, response:
ERROR
Test Command
AT+QSOC=?
Response
+QSOC=(list of supported <domain>s),(list of supported
<type>s),(list of supported <protocol>s)[,(list of supported
<cid>s)]
OK
<domain> Integer type;
1 IPv4
2 IPv6
<type> Integer type;
1 TCP
2 UDP
3 RAW
<protocol> Integer type;
1 IP
2 ICMP
<cid> Integer type; PDP context ID, AT+QGACT response.