NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 58 / 73
6.5. AT+QNBIOTRAI NB-IoT Release Assistance Indication
This command is used to set the NB-IoT release assistance indication as follows:
• No information available
• TE will send only 1 UL packet and no DL packet is expected
• TE will send only 1 UL packet and only 1 DL packet is expected
Parameter
6.6. AT+QATWAKEUP Enable Deep Sleep Wakeup Indication
This command is used to enable an unsolicited result code on a channel that indicates when the modem
is fully woken up after a deep sleep.
AT+QNBIOTRAI NB-IoT Release Assistance Indication
Test Command
AT+QNBIOTRAI=?
Response
+QNBIOTRAI: (list of supported <rai>s)
OK
Execution command
AT+QNBIOTRAI=<rai>
Response
OK
Otherwise response:
ERROR
Read Command
AT+QNBIOTRAI?
Response
+QNBIOTRAI: <rai>
OK
<rai> Integer type. Specifies release assistance information:
0 No information available (or none of the other options apply) (default)
1 TE will send only 1 UL packet and no DL packets expected
2 TE will send only 1 UL packet and only 1 DL packet expected
AT+QATWAKEUP Enable Deep Sleep Wakeup Indication
Test Command
AT+QATWAKEUP=?
Response
+QATWAKEUP: (list of supported <enable>s)
OK
To Next Page
Loading...
