NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 8 / 73
Table 1: Types of AT Commands and Responses
Each time a single AT command is supported. When execution of the previous AT command is finished,
the next AT command will be executed.
1.3. Supported Character Sets
The BC26 AT command interface defaults to the IRA character set. The BC26 supports the following
character sets:
GSM
UCS2
HEX
IRA
PCCP437
PCDN
8859-1
The character set can be configured and interrogated using the AT+CSCS command (3GPP TS 27.007).
The character set is defined in 3GPP specification 27.005.
This command returns the list of parameters and value ranges
set by the corresponding Write Command or internal
processes.
This command returns the currently set value of the parameter
or parameters.
This command sets the user-definable parameter values.
This command reads non-variable parameters affected by
internal processes in the module.
To Next Page
Loading...
Need help?
General
