NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 59 / 73
Parameter
Example
AT+QATWAKEUP=1 //Enable wakeup indication
OK
(Modem goes into deep sleep mode)
(Modem is woken up from deep sleep mode)
+QATWAKEUP //Modem fully woken up and ready to receive AT commands/data
6.7. AT+QENGINFO Query Current Network Status
This command is used to query current modem status information for serving cell and current network
status.
Execution Command
AT+QATWAKEUP=<enable>
Response
OK
Otherwise response:
ERROR
Read Command
AT+QATWAKEUP?
Response
+QATWAKEUP: <enable>
OK
<enable> Integer;
0 Disable indication on this channel when modem wakes up from deep sleep
1 Enable indication on this channel when modem wakes up from deep sleep
AT+QENGINFO Query Current Network Status
Write Command
AT+QENGINFO=<mode>
When <mode>=0:
Response
+QENGINFOSC:<sc_earfcn>,<sc_earfcn_offset>,<sc_pci
>,<sc_cellid>,[<sc_rsrp>],[<sc_rsrq>],[<sc_rssi>],[<sc_s
nr>],<sc_band>,<sc_tac>,[<sc_ecl>],[<sc_tx_pwr>]
[*MENGINFONC:<nc_earfcn>,<nc_earfcn_offset>,<nc_pc
i>,<nc_rsrp>,[…]]
To Next Page
Loading...
Need help?
General
