Quectel BC26 - AT+QSPCHSC Set Scrambling Algorithm

NB-IoT Module Series
BC26 AT Commands Manual
BC26_AT_Commands_Manual 56 / 73
Parameter
6.3. AT+QSPCHSC Set Scrambling Algorithm
This command is used to select new or old scrambling code. This is because code has been updated by
3GPPP, and UE needs to select correct code for network.
If there is any error, response:
ERROR
Test Command
AT+QRESET=?
Response
+QRESET: (list of supported <mode >s)
OK
If there is any error, response:
ERROR
<mode> 1 Reset the UE
AT+QSPCHSC Set Scrambling Algorithm
Execution Command
AT+QSPCHSC=<mode>
Response
OK
Otherwise response:
ERROR
Test Command
AT+QSPCHSC=?
Response
+QSPCHSC: (list of supported <mode>s)
OK
Otherwise response:
ERROR
Read Command
AT+QSPCHSC?
Response
+QSPCHSC: <mode>
OK
Otherwise response:
ERROR