GNSS Module Series
L80&L80-R&L86&LC86L EVB User Guide
L80&L80-R&L86&LC86L_EVB_User_Guide 26 / 30
Figure 19: Set TTFF Time-out (Sec)
In general, if hot start is selected, it is recommended to set “TTFF Time-out (sec)” to 10 s. If warm start is
selected, it can be set as 50 s. Lastly, if cold start is selected, it can be set as 100 s. “TTFF Time–out
(sec)” can help judge TTFF and save time.
Step 4: After all above operations have been performed, click the “Run” button to start the test. The test
can be stopped by clicking the “Stop” button.
To Next Page
Loading...
Need help?
General
