OPERATION
POWER ON/OFF
Before powering on the Scuba Tector Pro, make sure the angle between handle and coil is larger than 90 degrees, to avoid
coil interference.
Press the power button once to turn on the detector. A long and two short sounds will be heard, the battery indicator flashes
once in red and goes out, and the screen shows the battery status, alarm mode & sensitivity level for 3 seconds, then
displays “SCUBA TECTOR”. The white search light is on on default when the Scuba Tector Pro is powered on, but if the
search light is deactivated, it will be off when the detector is powered on.
The detector will automatically retune itself when switched on, so please keep the detector away from metal objects when
switching it on.
To power off the detector, press and hold the power button for 1 second. When the detector is turned off, the settings will be
saved automatically.
DETECTING MODE
There are 3 detecting modes: Audio, Vibration, Audio
and
Vibration
While the detector is on, press the Mode button to switch between the detecting modes.
SENSITIVITY SETTING
There are 4 levels of sensitivity. While the detector is on, click the Power button while holding the Mode button and note the
number of beeps. One beep indicates level 1 (Low), two beeps level 2 (Middle), three beeps level 3 (High) and one long
beep is level 4 (Boost). Each click of the power button (while holding down the Mode button) will cycle through the
sensitivity levels.
In highly mineralized areas, the detector may produce false signals, in this cases reducing the sensitivity level may help.
SEARCH LIGHT CONTROL
While the detector is on, press and hold the Mode button for
4
seconds, then remove the finger when you hear a short
sound. Then you can click the Mode button to deactivate or activate the search light. You need to power off the detector to
save the search light setting.
To Next Page
Loading...
Need help?
General
