To Next PageTo Next PageWhat to do if my Quest Engineering Metal Detector shows overload alarm?
If your Quest Engineering Metal Detector is displaying an overload alarm, especially on a beach or highly mineralized ground, switch to WET BEACH or SALT WATER MODE.
Why is my Quest Engineering Q30 Metal Detector so noisy?
If your Quest Engineering Metal Detector is producing excessive noise, try the following: * Perform an automatic or manual Ground Balancing. * Lower the sensitivity setting. * Move to a different location with less interference.
How to fix a Quest Engineering Q30 Metal Detector that doesn't make a sound?
If your Quest Engineering Metal Detector isn't producing any sound, check the cable connection between the coil and the control unit. Also, ensure that the volume isn't set to zero and that the wireless headphones mode isn't activated.
How to fix Quest Engineering Q30 that doesn't start?
If your Quest Engineering Metal Detector doesn't start, recharge it. If the issue persists, contact your dealer.
General| Brand | Quest Engineering |
|---|---|
| Model | Q30 |
| Category | Metal Detector |
| Language | English |
Filters magnetic field to ignore ground mineralization, with automatic adjustment feature.
Determines electronic waves sent into ground, affecting target depth and size detection.
Impacts search depth and sensitivity to disturbances; lower sensitivity reduces interference.
Uses metal ID numbers (1-99) to ignore unwanted objects like nails.
More flexible discrimination to ignore specific metal ID segments or search only within them.
Determines the exact position of a found object for accurate digging.
Target ID Arc shows segments indicating metal IDs based on conductivity.
Constant background audio signal to help detect very small targets.
Different tones for targets, tone break points, and iron tone volume setup.
Changes detector frequency to minimize interference from other sources.
Optimized for high-trash areas like parks with default discrimination.
Suitable for open fields with lower electromagnetic interference.
Optimized for beaches and highly mineralized saltwater conditions.
Modes for gold prospecting with adjustable threshold and tone options.
Navigate target ID arc and activate/deactivate IDs using buttons.
Regulate background sound volume and switch between tone modes.
Setup volume of iron tones to discriminate unwanted items.
Choose one of 5 channels to minimize interference.
Calibrate for mineralization to reduce false signals.
Perform automatic or manual ground balancing to adjust to soil conditions.
Reset the detector to factory settings by holding a button.
Move slowly, swing coil 3cm above ground, overlap swings for full coverage.
Waterproof usage up to 5m, notes on headphones, saltwater mode, and rinsing.
Use Pinpoint-function to find exact object position, then dig carefully.
Connect magnetic charging cable to control unit and power supply.
Steps for connecting wire, underwater, and wireless headphones.
Avoid cable damage, extreme temperatures, chemicals, and protect contacts.
Turn off, wipe with soft cloth, and dry completely.
Recharge detector or contact dealer if issue persists.
Check coil connection, volume, or wireless headphone mode.
Perform ground balancing, lower sensitivity, or change location.
Check for broken coil cable or contact dealer.
Switch to WET BEACH or SALTWATER MODE for mineralized ground.
