To Next PageTo Next PageTo Previous PageTo Previous Page
What to do if my Quest Engineering Metal Detector shows overload alarm?
If your Quest Engineering Metal Detector is displaying an overload alarm, especially on a beach or highly mineralized ground, switch to WET BEACH or SALT WATER MODE.
Why is my Quest Engineering Q30 Metal Detector so noisy?
If your Quest Engineering Metal Detector is producing excessive noise, try the following: * Perform an automatic or manual Ground Balancing. * Lower the sensitivity setting. * Move to a different location with less interference.
How to fix a Quest Engineering Q30 Metal Detector that doesn't make a sound?
If your Quest Engineering Metal Detector isn't producing any sound, check the cable connection between the coil and the control unit. Also, ensure that the volume isn't set to zero and that the wireless headphones mode isn't activated.
How to fix Quest Engineering Q30 that doesn't start?
If your Quest Engineering Metal Detector doesn't start, recharge it. If the issue persists, contact your dealer.
General| Brand | Quest Engineering |
|---|---|
| Model | Q30 |
| Category | Metal Detector |
| Language | English |
